NavCom Sapphire Rev.J - Manual (Page 228)

Sapphire Technical Reference Manual Rev. J
228
1.185 SOLIDEARTHTIDE (ASCII)
SF-3050 Sapphire SF-3040
This command is used to enable or disable the correction of solid earth tide. This command
causes a response, which includes the [SOLIDEARTHTIDE] mnemonic followed by the ON/OFF
setting.
Command: [SOLIDEARTHTIDE] {mode}
Parameter Definition
Mode
Keyword (ON, OFF) to enable/disable the solid earth tide correction. If this argument is
empty, the receiver will return the current setting of the enable flag.
Examples: [SOLIDEARTHTIDE]ON
Request to enable solid earth tide correction
OK [SOLIDEARTHTIDE]
Response from the receiver
[SOLIDEARTHTIDE]
Request for solid earth tide correction enable status
[SOLIDEARTHTIDE]ON
Response shows solid earth tide correction is enabled
[SOLIDEARTHTIDE]OFF
Request to disable solid earth tide correction
OK [SOLIDEARTHTIDE]
Response from the receiver
[SOLIDEARTHTIDE]
Request for solid earth tide correction enable status
[SOLIDEARTHTIDE]OFF
Response shows solid earth tide correction is disabled

When solid earth tide is on, its correction will be automatically applied to the
StarFire
™ single and dual position solution. It will not be applied to non-differential
and SBAS mode solutions as these corrections are too small compared to the
solution accuracy appropriate in those modes. It also will not be applied to the
position solution in relative positioning modes of RTK, RTK-X, and code dGPS
.
1.186 Reserved