NavCom Sapphire Rev.J - Manual (Page 106)

Sapphire Technical Reference Manual Rev. J
106
[ETHVCOM] OFF, 0.0.0.0, 0, UDP1, 4362, ETH2
[ETHVCOM] OFF, 0.0.0.0, 0, TCP1, 4363, ETH3
[ETHVCOM] OFF, 0.0.0.0, 0, TCP1, 4364, ETH4
Enter [ETHCONFIG] with no parameters to view the current Ethernet Port IP settings to use for
the connections dialog:
[ETHCONFIG]AUTO,204.54.86.4,255.255.254.0,204.54.87.1,204.54.87.20,204.54.
87.39, where
“204.54.86.4” – your IP address; make a note of this
“255.255.254.0” – network address mask
“204.54.87.1” – gateway address
“204.54.87.20” – primary DNS server
“204.54.87.39” – secondary DNS server
The [ETHCONFIG] command can also be entered with MANUAL; AUTO
means use DHCP and MANUAL means assign a fixed IP. You can use
AUTO, but keep in mind that if the receiver drops offline, it may be difficult to
retrieve the IP address. If you specify MANUAL, the IP address does not
change if the receiver drops offline for power cycle, downline load of new
firmware, etc.
Example:
[ETHCONFIG]MANUAL,204.54.86.4,255.255.254.0,204.54.87.1,204.54.87.20,
204.54.87.39

To make the change to MANUAL permanent, enter [PROFILE]SAVEAS
“PROFILENAME” and power cycle the receiver.

For further information, refer to the ETHCONFIG and PROFILE commands in this
manual. For help getting online, refer to Chapter 2 of the StarUtil 3000 User Guide.