NavCom Sapphire Rev.J - Manual (Page 198)

Sapphire Technical Reference Manual Rev. J
198
1.144 REFNAME (ASCII)
SF-3050 Sapphire SF-3040
This command is used to define the reference station name for base station mode of operation.
When the Sapphire engine has been configured to operate as a dGPS base station, the
reference station name is used to support the transmission of a character string indicating the
name of the reference station.
Command: [REFNAME] “name”
Parameter Definition
name
Reference station name (string) (1 to 10 characters; must be captured within quotation
marks “”)
Default: REF1
The stored reference station name will be used while composing the following messages:
CMR Type 2 (long station ID field)
CMR Type 4 (long station ID, subframe 3)
RTCM Type 16 (starting at position 7)
RTCM Type 1033 (receiver name field)
The format is as follows:
“COMPANYNAME RECEIVERNAME:REFNAME”, where
 “COMPANYNAME” is NAVCOM

RECEIVERNAME is the product name

REFNAME is the string set by the [REFNAME] command
Examples: [REFNAME] “HELLYER”
Sets reference name to HELLYER, which might be a location for RF Tower 59
Query stored value:
[REFNAME]
[REFNAME]”HELLYER”