NavCom Sapphire Rev.J - Manual (Page 112)

Sapphire Technical Reference Manual Rev. J
112

USBMODE] command in this manual.
Examples: [FSCD]
Returns the current working directory
[FSCD] “my_directory”
Changes the working directory to
“my_directory”. If this directory does not exist, the
following message will be output:
[FSCD]UNKNOWN DIRECTORY
[FSCD] “..”
Changes the working directory to the parent directory of the current working
directory
[
FSCD] “/”
[FSCD] “\”
Changes the working directory to the root directory
[FSCD] “/directory_1/directory_2/directory_3”
[FSCD] “\directory_1\directory_2\directory_3”
Changes the working directory to the
root_directory\directory_1\directory_2\directory_3
[FSCD] “./directory_1/directory_2/directory_3”
[FSCD] “.\directory_1\directory_2\directory_3”
Changes the working directory to the
current_directory\directory_1\directory_2\directory_3

Once USB mode is changed to Mass Storage Device mode, the onboard file
system commands cannot access the SD flash. The following message is output:
[FSCD]"ACCESS DENIED: USB IS IN MASS STORAGE MODE"

When changing the USB from Mass Storage Device mode to other modes, please
allow approximately 1 minute for the SD flash to be reconfigured and the onboard
file system to be reinitialized before implementing the onboard file system
commands.
1.61 FSCWD (ASCII)
SF-3050 Sapphire SF-3040
This command is used to query the current working directory.
Command: [FSCWD]