NavCom Sapphire Rev.J - Manual (Page 146)

Sapphire Technical Reference Manual Rev. J
146
9. USBMODE] command to switch from USB to Mass Storage mode, logging will be
automatically terminated.
1.97 If the USB is currently in Mass Storage mode, starting data logging on drive A
will fail. Before logging data on drive B, use [UPTIME
This command is used to retrieve the total time the receiver has been running since boot up OR
since the last time the user rest the timer.
Command: [UPTIME] RESET
Parameter Definition
RESET
RESET will reset the start time to the current time, so that the user can use this as a
counter from a specific point in time.
If the RESET parameter is not specified, the command will return the total time the receiver
has been running or since the last time the time has been reset.
Examples:
[UPTIME]
[UPTIME]1 day, 20:56:19
[UPTIME]RESET
[OK] UPTIME
[UPTIME]
[UPTIME]00:00:02