NavCom Sapphire Rev.J - Manual (Page 124)

Sapphire Technical Reference Manual Rev. J
124

When a user enters [FSFORMAT]A:,DEFAULT to start formatting the internal SD
flash, the following message is output if mounting failed:
[FSFORMAT] ERROR ON MOUNTING SD FLASH

When a user enters [FSFORMAT]A:,DEFAULT to start formatting the internal SD
flash, the following message is output if the SD flash is still being mounted:
[FSFORMAT] SD FLASH IS BEING MOUNTED, PLEASE WAIT

While formatting, the following messages are output:
[OK] FSFORMAT
[FSFORMAT]A: FORMATTING 1 SECONDS
[FSFORMAT]A: FORMATTING 2 SECONDS
………………….
[FSFORMAT]A: FORMATTING 53 SECONDS
[FSFORMAT]A: FORMATTING DONE - FAT32

[FSFORMAT] may take up to 1 minute for [FSFORMAT] to be completed. Once
formatting is done, the following message will be output:
[FSFORMAT]A: FORMATTING DONE – FAT type

Once USB mode is changed to Mass Storage Device mode, the onboard file
system commands cannot access the SD flash. The following message is output:
[FSFORMAT]"ACCESS DENIED: USB IS IN MASS STORAGE MODE".

When changing the USB from Mass Storage Device mode to other modes, please
allow approximately 1 minute for the SD flash to be reconfigured and the onboard
file system to be reinitialized before implementing the onboard file system
commands.