NavCom Sapphire Rev.J - Manual (Page 175)

Sapphire Technical Reference Manual Rev. J
175
1.121 NTRIPSERVER (ASCII)
SF-3050 Sapphire SF-3040
This command controls the behavior of the NTRIP server. If no keyword is specified, the status
is displayed.
Command: [NTRIPSERVER] {NONE} {CONNECT} {DISCONNECT}
Parameter Definition
None Keyword that displays the server status
Connect Keyword that commands the server to connect to the caster mountpoint
Disconnect Keyword that commands the server to disconnect from the caster
Examples: [NTRIPSERVER] CONNECT
Connects to the NTRIP caster
[NTRIPSERVER]
Displays current status
[NTRIPSERVER]MAKING MOBILE CONNECTION
The NTRIP client and server cannot both be active at the same time. An error
message will be displayed if any keyword other than a status request or
DISCONNECT is issued to one while the other is active.
1.121.1 NTRIP Server Status Messages
The NTRIP server reports status messages back through the same port from which it received
the [NTRIPSERVER] command. This port number is saved in RAM and is initialized to an
invalid port number at power-on. Status messages are only displayed after the first
[NTRIPSERVER] command after power-on. Refer to Table 72 for details.
Table 72: NTRIP Server Status Messages
State Action Message Description
ANY CONNECT
command NTRIP CLIENT BUSY NTRIP client not in idle state.
Command will not be
processed.
NTRIP SERVER BUSY NTRIP server not in idle state.
Command will not be
processed.
IDLE CONNECT
command INVALID CASTER INFO –
Name: Port: Mountpoint:
Necessary caster information
unavailable. Command will not
be processed.
IDLE Auto-connect field
set to SERVER AUTOCONNECTING NTRIP
SERVER NTRIP server is attempting to
auto-connect with current
configuration information.
WAIT FOR
MOBILE Attempting to
connect via modem COULD NOT MAKE
MOBILE CONNECTION Failure to connect to the
wireless service provider.
Return to IDLE state.
CONNECT Attempting TCP/IP COULD NOT ALLOCATE Internal TCP/IP stack error.