NavCom Sapphire Rev.J - Manual (Page 355)

Sapphire Technical Reference Manual Rev. J
355
2.95 RADIOSTAT (ASCII)
SF-3050 Sapphire SF-3040
This message reports the current radio status for the SF-3040. This is an ASCII message.
Table 185: RADIOSTAT Message
Condition Response
Radio off [RADIOSTAT] Radio off
Radio not responding [RADIOSTAT] No response from radio
Radio on and responding
[RADIOSTAT] RX field strength (dBm), TX frequency
(MHz), TX power (mW), RX threshold (dBm), Network ID
(integer), software version number (Vxx.yy.etc), serial
number (9-digit number), channel width (kHz), software
protocol (1-digit number), GPS week number, GPS time of
week in seconds.
The GPS week and time of week were appended to the
[RADIOSTAT] message in ver 3.2.7.
SF-3040 v2.1.7 software did not report channel width and
protocol in [RADIOSTAT], and only the first 6 characters
of the 450MHz radio version were output (V06.16).
Example (v2.1.7):
[RADIOSTAT] -65 dBm, 464.95000 MHz, 100 mW, -117 dBm, 1, V06.16, 094942347
Examples (v3.0.12):
RADIOSTAT] -65 dBm, 464.95000 MHz, 100 mW, -117 dBm, 1, V06.16.3.45,
094942347, 25.0 kHz, 0
[RADIOSTAT] -65 dBm, 464.95000 MHz, 100 mW, -117 dBm, 1, V06.16.3.46.3,
094942347, 12.5 kHz, 0
Examples (v3.2.7):
[RADIOSTAT] -55 dBm, 464.75000 MHz, 100 mW, -117 dBm, 1, V06.16.3.48.10,
114200013, 12.5 kHz, 0, 1660, 237465.000
[RADIOSTAT] -70 dBm, 464.75000 MHz, 100 mW, -115 dBm, V06.16.3.46.3,
114200014, 25.0 kHz, 3, 1660, 238383.600
[RADIOSTAT] Radio off, 1660, 238334.800
The values reported here are the current radio status and settings. The TX frequency, TX
power, RX threshold, and network ID should match what was specified in the previous [RADIO]
command.

RADIOSTAT cannot be scheduled ONCHANGE. Doing so would require
continuously polling of the radio, which disrupts data communications.