NavCom Sapphire Rev.J - Manual (Page 243)

Sapphire Technical Reference Manual Rev. J
243
1.207 WEBCONTROL
SF-3050 Sapphire SF-3040
This command is used to enable/disable the web server on the receiver as well as direct the
source of the webpages. Although this command is accepted by the SF-3040 and the Sapphire
unit, it only affects the performance of the SF-3050 unit.
Command: [WEBCONTROL] mode,source
Parameter Definition
Mode
Keyword: (ENABLE/DISABLE)
This keyword will either Enable or Disable the web server on the unit, if this command was
previously enabled and then set to disable, then the unit will have a listener already set to
accept connections, however it will not do anything with the requests that come in, but will
simply ignore them. Therefore, in order to fully disable the web server and prevent any TCP
connections to port 80, it is recommended that this command be set to disable, save the
profile, and then reboot the unit for it to fully take effect.

This keyword is independent of the source argument. It will
enable/disable the webpage regardless of the source.
Default: ENABLE
Source
Keyword: (NCT/OEM)
The webpages are stored in the internal storage of the SF-3050 under a specific directory:
A:/WEB/NCT or A:/WEB/OEM. This allows the user to access either the NCT webpages or
the OEM webpages with the effect of this argument. Both locations can have webpages
stored in them simulatinously, however only one can be accessed at a time depending on
this argument variable
Default: NCT
Examples
[WEBCONTROL]DISABLE
Will disable the access to the web server
[WEBCONTROL]ENABLE, NCT
Will enable the access to the web server and will change the web server to look under
A:/WEB/NCT in the hidden webdrive for the web pages
[WEBCONTROL] , OEM
Will change the web server to look under A:/WEB/OEM in the hidden webdrive for the
web pages