NavCom Sapphire Rev.J - Manual (Page 293)

Sapphire Technical Reference Manual Rev. J
293
2.44 NCT5E (Binary)
SF-3050 Sapphire SF-3040
This output message is used to send the raw measurements from a RTK base site to the rover
receiver.

When a receiver is configured as a RTK rover, Sapphire and the SF-3050 support
both the Sapphire NCT5E message (GPS+GLONASS) and the legacy Starlight
0x5E message (GPS only). When the receiver is configured as a RTK base,
Sapphire and the SF-3050 do not support the Starlight 0x5E message with this
message.
To use Sapphire as base and a NCT 2100D product (e.g., SF-2050) as rover, configure
Sapphire to output the NCT5B message. The NCT5B message provides the same
navigation performance as the Starlight 0x5B or 0x5E message, based on the hardware
configuration (NCT-2000D or NCT-2100D respectively).

Additional information may be available for key channel partners and will require a
Non-Disclosure Agreement with NavCom. Contact NavCom Customer Support at
[email protected] for further details.
2.45 Reserved
2.46 Reserved
2.47 Reserved
2.48 Reserved