NavCom Sapphire Rev.J - Manual (Page 165)

Sapphire Technical Reference Manual Rev. J
165
1.115 MULTISATTRACK
This command is used to enable or disable multi-satellite tracking. It also enables or disables
automatic bandwidth reduction and can set the fixed bandwidth or the minimum bandwidth
when in automatic bandwidth mode.
Command: [MULTISATTRACK] multi_enable, max_bandwidth_hz, min_bandwidth_hz
Parameter Definition
multi_enable Enables multi-satellite tracking (keyword ON,OFF)
max_bandwidth_hz
This is the fixed bandwidth the receiver uses when multi-satellite tracking is OFF and
the maximum bandwidth the receiver uses when multi-satellite tracking is ON.
Float(2.5,5,10,20)
min_bandwidth_hz
This is the minimum bandwidth the receiver uses when multi-satellite tracking is ON.
It must be less than or equal to the maximum bandwidth. When multi-satellite
tracking is OFF, this parameter is not used. Float(2.5,5,10,20)
Default : mutli_enable = ON; bandwidth = 20
Examples:
[MULTISATTRACK] on,10,5
Enables multi-satellite tracking with a maximum bandwidth of 10 and minimum
bandwidth of 5 Hz
[MULTISATTRACK]off,10
Sets tracking mode to fixed bandwidth of 10Hz
[MULTISATTRACK] on,10,10
Enables multi-satellite tracking with fixed bandwidth of 10 Hz