NavCom Sapphire Rev.J - Manual (Page 142)

Sapphire Technical Reference Manual Rev. J
142
[LOGFILE]A:,RUNNING,”RUNNING 0 BYTES LOGGED”
[LOGFILE]A:,FORCESTART
Forces file logging on drive A

Essential Notes:
1. When the receiver is first turned on, or the USB mode is changed from Mass Storage
device mode to COM port mode for the SF-3040, and the USB mode is changed from
Mass Storage device mode to COM port mode or Host mode for Sapphire, the SD
removable card or the SD flash internal memory is reconfigured. If the user sends the
command [LOGFILE]A:,START before the reconfiguration is finished, the following
message is output:
For SF-3050 [LOGFILE]A: SD FLASH IS BEING MOUNTED, PLEASE WAIT
For SF-3040: [LOGFILE]A: SD CARD IS BEING MOUNTED, PLEASE WAIT
If the SDCARD message is turned on for this port, the following [SDCARD]
message is output:
[SDCARD] MOUNTING… 5
[SDCARD] MOUNTING… 6
[SDCARD] MOUNTING… 7
[SDCARD] MOUNTING…8
The numeral represents the SD card mounting time in seconds. Upon successful
completion of mounting, data logging starts.
If mounting fails, the following message is output:
For the SF3050:
[LOGFILE]A: ERROR ON MOUNTING SD FLASH
For the SF-3040:
[LOGFILE]A: ERROR ON MOUNTING SD CARD
For the SF-3040:
If the SD card is not present and the user sends the command
[LOGFILE]A:,START, the following message is output:
[LOGFILE]A: SD CARD IS NOT PRESENT
If the SD card is present and locked and the user sends the command
[LOGFILE[A:,START, the following message is output:
[LOGFILE]A: SD CARD IS LOCKED
2. When the USB mode is changed to Host mode, the USB thumb drive (external device)
needs to be enumerated (enumeration takes up to 1 minute; log data on drive B only
after enumeration is finished). If the user sends the command [LOGFILE]B:,START
before enumeration is complete, this message is output: