NavCom Sapphire Rev.J - Manual (Page 163)

Sapphire Technical Reference Manual Rev. J
163
1.112 MPAUTOCONNECT (ASCII)
SF-3050 Sapphire SF-3040
This command is used to set multiple mount points for the NTRIPCLIENT connection.
Command: [MPAUTOCONNECT] mode,"mp1","mp2","mp3",..."mp10"
Parameter Definition
Mode
Keyword (ON, OFF)
ON: The user must specify at least one mount point for the ntripclient to attempt to connect to.
The NTRIPCLIENT will try to connect to each of the listed mount points in order if the current
mount point times out and will attempt to reconnect 10 times. After reaching the last
mountpoint, NTRIPCLIENT will continue to try to reconnect by starting all over again using the
first mountpoint listed. This command will override [NTRIPCONFIG] mountpoint arg after
setting up the new mount point.
OFF: The user will not need to specify any additional mountpoints. The NTRIPCLIENT will
only attempt to reconnect using the current mount point specified in NTRIPCONFIG
MP1-10
Keyword (dynamic caster mount points)
If the Mode is ON, then the user can specify up to 10 mount points for the NTRIPCLIENT to
attempt to make a connection. These mountpoints must follow the RTCM mount point naming
convention which allows only the use of
alphanumeric characters, “.”, “-’’, and “_”.
[NTRIPCLIENT] will continue to attempt to make a reconnection based on the given mount
point.
Default: mode = OFF.
Examples:
[MPAUTOCONNECT]ON, “RTCM3.0”,”RTCM2.3”,”RTCM3.1”
The receiver will cycle through each of these mountpoints as needed. If RTCM3.0 fails to
automatically establish a connection after 10 tries, then RTCM2.3 will be tried and
NTRIPCONFIG will be overridden with this mountpoint information, and so forth. If
RTCM3.1 fails to establish a connection, then RTCM3.0 will retry and the cycle will
continue.
[MPAUTOCON NECT]ON, “RTCM2.3”,”StarfireGNSS”
Overrides the list with RTCM2.3 and StarfireGNSS mountpoints
[MPAUTOCONNECT]OFF
Clears the list and disables the MP AUTOCONNECT. NTRIPCONFIG will alter the last
mountpoint until the user manually changes it.
[MPAUTOCONNECT]ON
Indicates an error. The user must specify at least one mountpoint.

This command will NOT take effect if the NTRIPCONFIG command does not set the client
to autoconnect.