NavCom Sapphire Rev.J - Manual (Page 337)

Sapphire Technical Reference Manual Rev. J
337
2.80 NTRIPSTAT
SF-3050 Sapphire SF-3040
This message is used to report events associated with the NTRIPCLIENT command. It can be
scheduled as OnChange output message for a specific port, and turned off by using the
command [OUTPUT].
The following examples were output on week 1690 and TOW 486398.
Table 170: NTRIPSTAT Message Output Examples
Output Format: [NTRIPSTAT]week,TOW:
Action Message
Issue a source table request [NTRIPSTAT] 1690,486398: Requesting Source Table
Download the source table [NTRIPSTAT] 1690,486398: Downloading SourceTable
Connect to a mount point [NTRIPSTAT] 1690,486398: Connecting to mountpoint …
Connect properly [NTRIPSTAT] 1690,486398: Connection Established
Disconnect [NTRIPSTAT] 1690,486398: Disconnected
Connection fail due to a
connection error
[NTRIPSTAT] 1690,486398:ERROR: Connection Failed
Inability to transmit any message
to the caster [NTRIPSTAT] 1690,486398: ERROR: Transmission failed, check what
is being output in NTRIP port. Disconnecting.
Inability to reconnect with the
same mountpoint 10 times [NTRIPSTAT] 1690,486398: ERROR Disconnected 10 times, retrying
with %s …
2.81 Reserved
2.82 Reserved
2.83 Reserved
2.84 Reserved