Gasboy CFN III Manager Manual V3.6 - Manual (Page 98)

Setting Up Tax Tables How to Set Up a Tax Table
Page 10-10 MDE-4871 CFN III Manager’s Manual for Windows® XP Embedded - Version 3.6 · August 2010
• 2 (two) indicates a tax that is calculated as a percentage of the whole dollar amount, and
then uses a lookup table for any remaining cents
Press RETURN to use the same type-that is, to indicate you are not changing the tax type.
If the tax number is type 0, the program returns to the first prompt. Zero is the default type,
so if you have not defined the tax number as a type 1 or 2, it is a type 0.
• To exit the program, enter Q.
Enter command (I, L, E, Q, D, P, M, or S)?
This prompt will be repeated until you enter Q to quit. Enter the commands, in order, that
define the compressed description of your tax table. Each command you enter causes the
program to ask for other information:
• Enter I to give an increment command. You will be prompted for the number of times the
increment applies and the taxable amount increment (Amt Diff on your worksheet).
• Enter L to start a loop. You will be prompted for the number of times to repeat the
commands that occur before the end loop command (the program will not allow you to
quit until you end all the loops you start).
• Enter E to end the last loop that was started.
• Enter Q to quit the program. You will be asked whether or not you want to save the
changes you have made to the table. You may respond with Y to save the changes, N not
to save the changes, or P to print the current table definition so you can decide whether or
not to save it (ensure that you cannot quit if there are loops that have been started but not
ended).
• Enter D to delete the last command you entered, including your responses to the command
prompts. If you enter D again, the previous command is deleted. You can continue
entering D until you delete as many entries as you wish, back to the Smallest taxable
amount prompt.
• Enter P to print the current table definition so you can review it. Refer back to the example
for a sample printout of the table definition.
• Enter M to modify a record. You will be asked for the number of the record to be
modified, then you can change that record’s smallest taxable amount.
• Enter S to see a display of the table’s status showing the record size and the number of
records used and available.
If you want to quit the program without saving any changes or ending your loops, use ^C
(press and hold the CTRL key, then press C).
Back Up Your Tax Data
After you have used the TAX program to enter a tax table, run SYSBACK to back up the data.