Gasboy CFN III Manager Manual V3.6 - Manual (Page 271)

MDE-4871 CFN III Manager’s Manual for Windows® XP Embedded - Version 3.6 · August 2010 Page A-3
Jumper Settings SC III Ports and Switches
PC Address Switch, SC-COMM CPU - S2
On the CPU board, card edge right, the PC address DIP sets where in the PC address space
the dual RAM will occur. The SC-Comm board currently assumes D0000.
Switch Address Switch Address
cl cl cl cl C0000 op cl cl cl D6000
cl cl cl op C3000 op cl cl op D9000
cl cl op cl C6000 op cl op cl DC000
cl cl op op C7000 op cl op op DF000
cl op cl cl CC000 op op cl cl E0000
cl op cl op CF000 op op cl op E3000
cl op op cl D0000* op op op cl E6000
cl op op op D3000 op op op op E9000
* The SC-Comm board currently assumes this address.
Jumper Settings
SC-Comm CPU Board Settings
Jumper Description Setting
K3 AC power fail sense 1-2-3 to disable*
K4 AC watch dog timer 1-2 to enable*
K5 SC-Comm CPU (testing only) 1-2 to reset
K6 RS-485 loop 1 2-3 for 4 wire*
1-2 for 2 wire
K7 RS-485 loop 2 2-3 for 4 wire
1-2 for 2 wire*
K8 Rx Clock from synchronous modem (DB-25-15) 1-2 to connect
K9 ETC output to synchronous modem (DB-25-24) 1-2 to connect
K10 Tx clock onput from synchronous modem (DB-25-17) 1-2 to connect
K11 EPROM type 2-3 for 27128 or 27256
K12 EPROM type 2-3 for 27128 or 27256
* = default