Gasboy CFN III Manager Manual V3.6 - Manual (Page 132)

Proprietary Cards Fuel Limitation Codes
Page 13-10 MDE-4871 CFN III Manager’s Manual for Windows® XP Embedded - Version 3.6 · August 2010
Fuel Limitation Codes
Limitation codes determine (limit) how much fuel can be purchased on the card in each
transaction.
To limit the amount of fuel that can be locally authorized for a single sale on a Proprietary
Card, you:
• Determine the fuel limitations for each card, in gallons (or litres) or dollars.
• Decide on a unique limitation code (one or two digits long) to represent each limitation.
• Encode the limitation codes on the cards, one to each card, as with authorization codes.
• Assign the limitation amounts to the appropriate limitation codes with the LOAD
LIMITATION command (discussed below).
Each card is then limited for any single transaction to the amount designated by the limitation
code on the card. Note that the limitation code on the card overrides the pump’s fill limit, but
not the pump’s maximum limit.
The card limit may not be exceeded in a single transaction; to purchase amounts greater than
the card limit, the card holder has to use multiple transactions.
How to Assign Fuel Limits to Fuel Limitation Codes
Use the command LOAD LIMITATION or LO LI to set the maximum fuel quantity allowed
for a limitation code. The limit can be in gallons (or litres) or dollars. To specify a dollar limit,
type a dollar sign ($) before the limit amount.
LOAD LIMITATION;C (LO LI;C)
[P:]* LOAD LIMITATION;C
↵
Limitation code? 1
↵
Limit? 20
↵
Limitation code? 2
↵
Limit? $30
↵
Limitation code?
↵
[P:]*
You may use the C option with the command LOAD LIMITATION to assign a limit amount to
more than one limitation code at a time.
How to Print Fuel Limitation Codes
Use the command PRINT LIMITATION or P LI to print the limitation codes and the limit
amount for each code. If the limit is in dollars, a dollar sign prints in front of the amount.
PRINT LIMITATION (P LI)
[P:]* PRINT LIMITATION
↵
Limitations
1 20.000 2 $30.000
[P:]*