Gasboy CFN III Manager Manual V3.6 - Manual (Page 74)

[P:]* LOAD PRICE;C
↵
Price code? 1
↵
Price level? 0
↵
Price? 1.149
↵
Price level? 1
↵
Price? 1.169
↵
Price level? 2
↵
Price? 1.199
↵
Price level?
↵
Price code?
↵
[P:]*
Tank and Pump Commands Method-of-payment Pricing
Page 8-6 MDE-4871 CFN III Manager’s Manual for Windows® XP Embedded - Version 3.6 · August 2010
The first method is to enter the new price for each price code and price level that you wish to
change. This method uses LOAD PRICE;C command.
The other method is to enter the amount of the price change as a quantity to be added to or
subtracted from the old price. This method can be used to raise or lower either all price levels
of one price code or all price codes by a specified amount.
The form for the second command is LOAD PRICE code level change where:
• code is replaced by the price code(s) to be changed (either a number or * for all price
codes),
• level is replaced by the level(s) to be affected (either a number or * for all levels),
• change is replaced by a + or - sign and the amount of the change in dollars and cents.
[P:]* LOAD PRICE * * +.05
↵
[P:]*
All Codes All levels
[P:]* LOAD PRICE 3 * -.02
↵
Price level ?
↵
[P:]*
This example raises all prices for all codes (indicated by the first asterisk after LOAD PRICE)
and all levels (the second asterisk) by five cents.
This next example subtracts two cents from all levels in price code 3.
Note: LOAD PRICE;I erases all price levels and price code prices for all pumps that have
been assigned price codes. This will disable all pumps. You must re-enter new prices for
all price codes and re-enable all pumps with ENABLE PUMP after you use this
command.