Gasboy CFN III Manager Manual V3.6 - Manual (Page 76)

Tank and Pump Commands Pump Commands
Page 8-8 MDE-4871 CFN III Manager’s Manual for Windows® XP Embedded - Version 3.6 · August 2010
Pump Commands
How to Assign Products, Prices, and Tanks to Hoses
Use the command LOAD FUEL or LO FU to enter the product code, price code, and tank
number to be assigned to each pump, or to each hose for Multi Product Dispensers (MPD
® ).
LOAD FUEL (LO FU)
[P:]* LOAD FUEL
↵
Pump number? 13
↵
Hose number? 1
↵
Product code? 1
↵
Price code? 1
↵
Tank number? 1
↵
Hose number? 2
↵
Product code? 2
↵
Price code? 2
↵
Tank number? 2
↵
Hose number?
↵
[P:]*
C
Number of Pump, Dispenser or MPD
Number of MPD Hose; All Others Enter 1
Code Created with LOAD PRODUCT
Price Code Created with LOAD PRICE
Number of Fuel Tank used by LOAD
TANK
[P:]* LOAD FUEL
↵
Pump number? *
↵
Hose number? 1
↵
Pumps that dispense the same product may be assigned different price codes. For example, a
full-service pump that dispenses unleaded regular fuel may be assigned a different price code
than a self-service pump that dispenses the same fuel. Price levels and prices are assigned to
price codes with LOAD PRICE.
The LOAD FUEL command allows you to specify different products, prices, and tanks for
each hose on a pump. If the system uses MPDs, a pump is one side of the MPD. That is, each
dollar and gallon display corresponds to one pump. For regular dispensers and pumps, there is
one hose per pump. The pump, not the hose, is authorized for transactions.
The number of pumps and associated hoses in the system is determined by the Site Controller
configuration.
You may use the C option with the command LOAD FUEL.
To set all pumps to be the same, enter an asterisk when prompted for the pump number in
LOAD FUEL. This will affect all pumps with the same hose number.