Gasboy CFN III Manager Manual V3.6 - Manual (Page 310)

Dialout Communications Modems
Page F-8 MDE-4871 CFN III Manager’s Manual for Windows® XP Embedded - Version 3.6 · August 2010
No Tones Produced When You Swipe a Card
If there is no tone produced when swiping a card, proceed as follows:
1 Check the phone numbers.
2 Make sure that the system parameters on page 4 and 5 of SYS_PAR have Remote
Authorization set to Credit.
3 Try cycling power to reset the modem.
No Connection
If there is no connection, proceed as follows:
1 Do you require to dial 9 first? Add a 9 and a comma (9,) to the front of the phone number or
check to see what the outside line command is.
2 Another method is to run Kermit on the site.
If the host port is 4, type
kermit 1200 l4 (note: that is L4, not fourteen)
Then type AT and press Enter. You must get 0 or OK back.
Now type ATDT 15551212, substituting the host number for the 555 number shown.
After the modem dials, type
AH0 (note: that is a zero)
to hang up the line. If the modem dials out, recheck the phone number, and ensure that the
network is set up properly.
Enter Shift Ctrl 6 and press Enter to leave Kermit.
Bad Connections with a 950 Number
There must be a backup 800 number. Put it in as the main phone number and see if a better
connection with the host results.