Gasboy CFN III Manager Manual V3.6 - Manual (Page 62)

Receipts, Messages, and Date Island Card Reader Messages
Page 6-6 MDE-4871 CFN III Manager’s Manual for Windows® XP Embedded - Version 3.6 · August 2010
How to Load Messages
Use the LOad MEssage (LO ME) command in the site controller to load broadcast messages.
These messages will appear on the first line of the Island Card Reader (ICR) or in-the-pump
reader display. To access other lines of a multiple line display, use the tilde character (~) and
the line # (1 to 4) before the message. The display times for messages 1 to 3 must be loaded as
0 seconds; message #4 display time must be greater than 0 seconds. This will allow the
messages on all 4 lines to display at the same time instead of one line at a time.
Note: If more than four messages are loaded (5-10), omit the tilde preceding the text for line
four and the messages will be scrolled in line four of the display. Many reader displays
will have less than four lines. In these cases, only load messages for the lines that are
available.
[P:]* LO ME;C
↵
Message number? 1
↵
Display in sec? 0
↵
Message? ~1WELCOME TO JOE’S
↵
Message number? 2
↵
Display in sec? 0
↵
Message? ~2TODAY’S SPECIAL IS
↵
Message number 3: 3
↵
Display in sec? 0
↵
Message: ~310W30 OIL
↵
Message number? 4
↵
Display in sec? 9
↵
Message? ~4HAVE A NICE DAY!
↵
Message number?
↵
[P:]*
If GASBOY ICRs are on a site along with multiple line display readers, the messages are
usually loaded as described in the previous example. If the GASBOY ICRs will be
communicating on the POS loop, the broadcast messages will not be displayed on them. The
GASBOY ICRs will display the message that is in the reader program under step-type 1,
which is usually Slide card or Insert card.
How to Delete Messages
To delete messages, proceed as follows:
1 Type REMOVE MESSAGE.
2 Enter message line number.
REMOVE MESSAGES;C (REM ME;C)
[P:]* REMOVE MESSAGE;C
↵
Message number? 1
↵
Message number? 5
↵
Message number?
↵
[P:]*
You can use the C option with REMOVE MESSAGE.