Gasboy CFN III Manager Manual V3.6 - Manual (Page 275)

MDE-4871 CFN III Manager’s Manual for Windows® XP Embedded - Version 3.6 · August 2010 Page B-3
Setup Instructions for C05899 - Credit/Debit Network Modem Modem Settings and Cables
Configuring to Use as a Credit/Debit Card Network Modem
To configure the modem, proceed as follows:
1 Use the diskette supplied with the modem to run the configuration utility,
PROGMODM.CMD. Insert the diskette into the A: drive and type A:PROGMODM. Follow
the instructions in PROGMODM for configuring as a bank network modem.
Note: Network modems are setup using a Network Setup menu, or by using the command
“MODEMS” and following the prompts that appear.
2 If you do not have the diskette containing the PROGMODM.CMD utility, follow the
procedure below. The symbol
↵ indicates that the Enter key must be pressed. After you
perform the following steps, run the commands in the following table for your specific
modem.
a Connect a terminal to the modem with a male DB-25 1:1 cable to male DB-25 (C04549) or
male DB-25 cable to female DB-9 (C04654). The terminal must be configured at the baud
rate at which the modem will operate.
b Type: AT&F&W
↵.
Modem response: No response from Multitech. All others respond with OK.
The modem is now ready for testing. The settings are saved, and power may be turned off
without losing the configuration.
CFN Router Configurations
If the router you are using does not use a MODEMS.INI file, choose the correct modem in the
router’s configuration menu. If the correct modem is not listed, choose Hayes 1200 for any of
these modems.
Modem Baud Rate Command
Multitech 1200 Type:
ATE0Q0V0X4&B1&Q1&D2&E3$MB1200S0=0S6=1S11=60&W
↵
Modem response: 0
2400 Type:
ATE0Q0V0X4&B1&Q1&D2&E3$MB2400S0=0S6=1S11=60&W
↵
Modem response: 0
Zoom 1200 Type: ATV0E0X4\N1S0=0S37=5S7=255S11=70&K0%C0&W
↵
Modem response: 0
2400 Type: ATV0E0X4\N1S0=0S37=6S7=255S11=70&K0%C0&W
↵
Modem response: 0
Boca Research 1200 or 2400 Type: ATV0X0E0L1&Q0&D2&C1&S0&W
↵
Modem response: 0
Hayes 1200 or 2400 Type: ATV0X0E0L1&Q0&D2&C1&S0&W
↵
Modem response: 0