Gasboy 215A - Manual

032138 Rev 1212 Page 1
INSTALLATION INSTRUCTIONS FOR
MODEL 215A FRONT LOAD VAPOR RECOVERY KIT 032137
This instruction sheet covers the instruction of the Model 215A Front Load Balanced System Vapor Recovery
Kit. If you are installing another manufacturer’s vapor recovery system, you may need to modify the nozzle boot
using the Modify Nozzle Boot instruction below. Vapor Recovery Kit, 032137 contains the following:
Item Part No. Description
1 032671 HHR Kit, Clamp and Reel, VR (GY
Prem)
2 063816 Support Bar, HHR
3 017930 Caplug-1-1/2 Sq. Tube
4 051956 Screw, 5/16-18x2, SS
5 068079 Washer, 5/16, SS
6 068874 Washer, Lock, Std Spring, 5/16, SS
7 056924 Spacer, HHR
8 013250 Bolt, 5/16 Mach Anchor HHR
9 047219 Plug Button, 7/8
10 038605 Nut, 5/16-18 Hex Keps
Item Part No. Description
11 064560 Swivel, Hose, 3/4, #36S
12 038502 Nozzle, Emco VR A4005 Stg II
13 030301 Hose, GY Max Prem, 7.5’
14 066817 Splitter, Emco, 4041-02
15 030407 Hose, 3/4” HW UL 1.5
16 017270 Bushing, 3/4 x 1
17 044007 Breakaway Coupling, Coax
OPW66CL0250
18 030303 Hose, GY Max Prem 4.5’
19 032138 Instructions (this sheet)
20 035282 Warnings and Safeguards Sheet
IMPORTANT:
Always use a UL-classified gas and oil resistant pipe compound on all male pipe threads when assembling
these components. All references to pipe compound in these instructions imply UL-classified pipe compound.
1. Read all instructions before beginning. A separate instruction sheet is packed with the EMCO Wheaton
splitter manifold, which is required for mounting this component. Also read and follow all precautions
regarding remote dispensers and pumps on the Warning and Safeguards Sheet, 035282, included in this kit.
2. Turn off power to the dispenser at the breaker and activate emergency shutoff valve.
3. Mount the splitter per the EMCO Wheaton instructions.
Assemble Product Jumper Hose
Assemble 3/4” x 1” bushing (017270) to dispenser outlet. Assemble 3/4” swivel (064560) to one end of the 3/4”
jumper hose (030407). Assemble fixed end of jumper hose to bushing on dispensing outlet, and the swivel end
at the splitter port labeled FUEL.
Mount Hose Retriever
1. Assemble clamp & reel assembly (Item 1) to support post (Item 2) with items 4, 5 & 6.
2. Install reel and post assembly to side of unit with Items 4, 5, 6, 7, & 10, and leave loose. Item 7 mounts
between post and side panel.
3. Making sure the support post is plumb, mark and drill a 5/8” dia. x 1-3/4” deep hole in island. Install anchor
bolt (item 8) into island surface. Install items 4, 5, and 6.
4. Tighten all hardware. Plug hole in post with item 9.
Modify Nozzle Boot
If using a long spout vapor-recovery nozzle, it may be necessary to remove the nozzle restraint bracket and the
lock.