Gasboy Q Series - Manual

020897 Rev. 06/12/03 Page 1
INSTALLING THE SUMP OVERFLOW CHECK VALVE
FOR Q SERIES SINGLE PUMPS
KIT #023900
023900 Kit Contents
Item Part No. Description
1 023997 Assembly, Sump Overflow Check Valve
2 020701 Vent Tube
3 020700 Assembly, Vent Tube
4 015191 Bracket, Sump Overflow
5 020702 Hanger, Conduit Size, 1-1/2"
6 051866 Screw, 1/4-20 x 1-1/4 HHC Pl
7 038860 Nut, 1/4-20 Hex
8 053919 Screw, 1/4-20 x 1/2 HH Taptite
9 026044 Fitting, 3/8 Elbow, Inverted Flared
10 058021 Grommet
11 020897 Instruction sheet (this sheet)
1. Turn off power to the pump. Unlock and open the doors. Trip the shear valve’s poppet to prevent fuel flow into
the pump.
2. Pre-assemble the conduit hanger (item 5) to the bracket (item 4)
using a ¼-20 x ½ Taptite screw (item 8). (NOTE: use the hole
that is ½” from the edge.) (Figure 1)
Figure 1
3. Slide the sump over flow assembly (item 1) into the conduit
hanger. Using the ¼-20 x 1-1/4 screw (item 6) and ¼” nut (item
7) to secure the sump over flow assembly loosely in place.
(Figure 2)
Figure 2