Gasboy CFN III Manager Manual V3.6 - Manual (Page 287)

MDE-4871 CFN III Manager’s Manual for Windows® XP Embedded - Version 3.6 · August 2010 Page D-5
Messages on the Log Printer Status and Error Messages
CFN Verification Came Up
Communication to a remote SC III or PC used for card verification has been re-established.
No action is required.
CFN Verification Did Not Respond
The SC III did not get a response when it contacted the host for remote verification of a card
transaction.
If this error occurs repeatedly, contact the system administrator.
CFN Verification Went Down
Remote communication has been lost.
Ensure that the modem is plugged in and the baud rate is set correctly. If everything looks
okay at your site, report the problem to the network administrator.
Profit PT #X Came Up
The indicated POS console has been returned to operation.
No action is required.
Profit Pt #X Disabled
The indicated POS console has been disabled by the command DISABLE CONSOLE.
No action is required. Return the console to operation with the command ENABLE
CONSOLE if appropriate.
Profit Pt #X Went Down
The indicated POS console is not functioning.
Try to return the console to operation with the command ENABLE CONSOLE.
If that does not work, check to make sure the console power cord is plugged in and that the
RS-422/485 Data Cable (small 4-wire Modular Connector) is connected.
If the console still does not work, execute the command PRINT DIAGNOSTICS 4 and report
the results to your service representative.
Data Corrupted in Table
Data in table has become corrupted. The SC III will reconstruct the table and reboot itself in
the crashed state.
Refer to “Name Table Reconstructed” on page D-1 .