Gasboy 9800Q - Manual

023412 Rev. 07/25/03
INSTALLING THE SWITCH ASSEMBLY ON NOZZLE BOOT
FOR 9800Q FRONT LOAD, KIT # 023411
023411 Kit Contents
Item Part No. Description
1 C04243 Switch Assembly
2 053625 Screw - #6-32 X 3/8 Taptite
1. Turn off power to pump/dispenser. Unlock and open the doors.
2. Disconnect the damaged switch from the harness.
3. Remove the two existing ¼-20 X ½ Taptite screws from the side of nozzle boot’s shroud and save it for later re-
installation.
4. Pull the switch-mounting bracket away from the nozzle boot’s shroud.
5. Remove the damaged switch by unscrewing the two existing #6-32 X 3/8 Taptite screws from the switch-
mounting bracket. Discard old switch and screws.
6. Install new switch assembly (item 1) with two new #6-32 X 3/8 Taptite screws (item 2) that are provided in the
kit.
7. Re-install the switch-mounting bracket (with the new switch assembly attached) to the nozzle boot shroud with
using the two ¼-20 X ½ Taptite screws that were saved in Step 3.
8. Connect the new switch to the harness and turn on power to pump/dispenser to test for proper operation.
9. Close and lock the doors.