Gasboy CFN III Manager Manual V3.6 - Manual (Page 296)

Status and Error Messages Messages in Command Mode
Page D-14 MDE-4871 CFN III Manager’s Manual for Windows® XP Embedded - Version 3.6 · August 2010
Cannot run program
You do not have a high enough permission level to execute the command you just entered.
Use the manager or supervisor key, if available, or get user with higher permission level to run
the command.
Card is not valid
You tried to lock out a card with the command LOCK CARD, but it was already locked out or
it was outside acceptable range.
You have limited lockout and tried to unlock an account number that matches a wildcard
number that is locked out.
You used CHECK CARD and the card number you entered was found to be not valid.
Card is valid
You tried to unlock a card with the command UNLOCK CARD, but it was already unlocked.
You have limited lockout and tried to lock out an account number that matches a wildcard
number that is unlocked.
You used CHECK CARD and the card number you entered was found to be valid.
Command failed
The command was unable to complete the requested action.
Device out of service
You tried to activate a pump with the command ACTIVATE PUMP, but the pump was not in
service.
Does not exist
You tried to execute a command, such as an enable or disable command, for a device that does
not exist.
You tried to execute a command for a product that does not exist.
Error loading program
Try to load the program again. If the message appears again, call your service representative.
Invalid option
You tried to use an option with a command that does not take that option.