Gasboy CFN III Manager Manual V3.6 - Manual (Page 233)

MDE-4871 CFN III Manager’s Manual for Windows® XP Embedded - Version 3.6 · August 2010 Page 22-1
Remote Authorizations Communications
22 – Communications
Remote Authorizations
Dial-out Phone Numbers
If your site uses a dial-out line for card-transaction authorization, you require to enter the
remote phone number—and the backup phone number, if there is one—into the Site
Controller. This is for CFN remote verification only. For bank networks, refer to the specific
manual.
How To Enter Dial-out Phone Numbers
Use the command LOAD PHONE or LO PH to enter the remote phone number(s).
LOAD PHONE (LO PH)
[P:]* LOAD PHONE
↵
Main (m) or Backup (b)? M
↵
Phone number? 367-6892
↵
[P:]*
1 Type LOAD PHONE.
2 Main or Backup? Enter M or B.
3 Phone number? Enter the phone number.
The main number is the number the Site Controller will call first; the backup number is the
number the Site Controller will call if it does not connect to the main number.
Usually the main and backup numbers are the same. That way the Site Controller will try to
dial the number again if it does not get through the first time.
You may specify other information about how the Site Controller is to dial the phone number:
• Use two commas in the phone number to insert a 2-second pause in dialing.
• Use a P before the phone number to specify pulse dialing, or use a T to specify tone
dialing. If you do not specify P or T, tone dialing will be used (if you have a PBX phone
system, you may require to first use pulse to obtain a line out, then switch to tone, which is
much faster, to dial the number of the remote host).
• You may use hyphens and parentheses in the phone number, but they are not required. The
Site Controller ignores the hyphens; they are for your convenience only.