Gasboy CFN III Manager Manual V3.6 - Manual (Page 270)

SC III Ports and Switches DIP Switch Settings
Page A-2 MDE-4871 CFN III Manager’s Manual for Windows® XP Embedded - Version 3.6 · August 2010
DIP Switch Settings
Memory Board DIP Switch SC-Memory I/O - S1
On the SC MEMORY I/O board top left DIP switch:
Position and Definition Setting
1 Boot to monitor after reset
Boot to OS after reset open
closed
2 Debug mode
Normal open
closed
3 Do not talk to PC when in monitor
Monitor I/O goes to PC also open
closed
4 Monitor I/O goes to SC port 1
No monitor I/O to SC port 1 open
closed
Memory Board DIP Switch SC-Memory I/O - S2
On the SC MEMORY I/O board top right DIP switch:
Position and Definition Setting
1 Battery 1 open=disabled
closed=enabled
2 Battery 2 External open=disabled
closed=enabled
3 N/A unused
4 N/A unused
PC IRQ Switch, SC-COMM CPU - S1
On the SC-COMM CPU board on the card edge side, the middle DIP switch is the
IRQ-enable DIP switch. The IRQ-enable switch chooses one of four possible interrupt
priorities. Only one may be selected and no other device on the PC can cause that interrupt.
SC3.EXE currently assumes level 10. Other choices are 15, 12, and 11.
Positions Definition Setting
1 Closed IRQ-15 Default - open
2 Closed IRQ-12 Default - open
3 Closed IRQ-11 Default - open
4 Closed IRQ-10 Default - closed