Gasboy CFN III Manager Manual V3.6 - Manual (Page 273)

MDE-4871 CFN III Manager’s Manual for Windows® XP Embedded - Version 3.6 · August 2010 Page B-1
Setup Instructions for C01533 - Answer Modem Modem Settings and Cables
Appendix B: Modem Settings and Cables
Setup Instructions for C01533 - Answer Modem
The modem comes factory-programmed with the correct command strings and you must
typically never require to perform this configuration.
The C01533 Answer Modem is identified by the following manufacturers and Model
Numbers:
• Zoom Faxmodem 56Kx Dualmode (white case) - Models 2948L, 2949L
• Zoom V.90 Faxmodem (black case) - Model 2948C
• Hayes Accura - Model 5611US, 5914US, or 4703US
• Boca Research - Model MV34ED, MV34FEMS, M144EW, or MD56AE
• Practical Peripherals - Model 5615US or 5638US
Configuring to Use as an Answer Modem
To configure the modem, proceed as follows:
1 Use the diskette supplied with the modem to run the configuration utility,
PROGMODM.CMD. Insert the diskette into the A: drive and type A:PROGMODM.
Follow the instructions in the PROGMODM for configuring as an Answer Modem.
2 If you do not have the diskette containing the PROGMODM.CMD utility, follow the
procedure below. The symbol
↵
indicates that the Enter key must be pressed.
a Connect a terminal to the modem with a 1:1 cable male DB-25 to male DB-25 (C04549) or
male DB-25 to female DB-9 (C04654). The terminal must be configured at the baud rate
at which the modem will operate.
b Connect the modem’s power cord and turn the modem power switch ON.
c For Zoom Model 2948C (V.90 Faxmodem, black case), enter the following:
Type: AT&F&W
↵
Modem response: OK.
Type: AT&D2S0=1&C1&Q6X0&K0+MS=nnnn
↵
Note: nnnn is a baud rate variable. Valid values are: V22 for 1200 baud, V22B for 2400
baud, or V32 for 9600 baud.
Modem response: OK.
Type: ATQ1&W
↵
Modem does not respond.