Metrohm tiamo 2.2 Manual - Manual (Page 973)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 ￭￭￭￭￭￭￭￭ 959
Measurement without drift control
If the option Measurement without drift control has been selected, then
the following parameters will be displayed:
Measuring time
Maximum period of time for measurement.
Range 0 ... 999999 s
Default value 120 s
Measuring interval
Time interval for entering a measuring point in the measuring point list. Max.
number of entries?
Range 0.1 ... 999999.0 s
Default value 2.0 s
Stop measured value
Stops when the preset measured value has been reached since the start of
the measurement.
Range 0 ... 1E+99
Selection off
Default value off
off
No stop.
Temperature
Temperature
Manually entered titration temperature. If a temperature sensor is connected
and the Temperature measurement is set on the General/Hardware
tab under Sensor to automatic or continuous, then the temperature will
be measured continuously.
Range -20.0 ... 150°C
Default value 25.0
5.6.4.9.4 MEAS Conc - Additional measured values
Tab: Method ▶ Commands ▶ MEAS Conc ▶ Properties... ▶ Additional measured
values
Command name
Name of the command.
Input 25 characters