Metrohm tiamo 2.2 Manual - Manual (Page 104)

3.1 Workplace - General ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
90 ￭￭￭￭￭￭￭￭ tiamo 2.2
Change layout Changes layout of the loaded workplace view (see Chapter 3.1.7.2, page 93).
Load view Loads a saved workplace view (see Chapter 3.1.7.3, page 94).
Save view Saves the current workplace view (see Chapter 3.1.7.4, page 94).
Run test Carries out run test for determination(s) (see Chapter 3.6.2, page 122).
Split vertically Splits workplace window vertically and display two workplaces side by side (see
Chapter 3.2.3.3, page 97).
Split horizontally Splits workplace window horizontally and display two workplaces below each
other (see Chapter 3.2.3.4, page 97).
Unsplit Unsplits the workplace window (see Chapter 3.2.3.2, page 97).
Logout Logout user (see Chapter 2.2.3, page 18).
MagIC Net Help Open MagIC Net Help.
3.1.5 Workplace - Subwindows
Program part: Workplace
Selection
The following subwindows can be displayed in the main window:
￭ Run
Window for the control of run sequences and entering of sample data.
This subwindow is permanently on display.
￭ Method
Display of the method currently loaded.
￭ Live display 1
Display of live curves, measured values and messages for the determina-
tion running.
￭ Live display 2
Display of live curves, measured values and messages for the determina-
tion running.
￭ Report
Display of reports of recorded determinations.
Presentation
The subwindows can be enlarged or made smaller to suit by dragging the
separating bar between the windows.
By clicking on the button above at the right, the subwindows can be
maximized so that only one subwindow is displayed in the main window.