Metrohm tiamo 2.2 Manual - Manual (Page 54)

2.4 Formula editor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
40 ￭￭￭￭￭￭￭￭ tiamo 2.2
Identifica-
tion Description Commands
.LP.TIM Time in s until the last measuring
point in the measuring point list is
reached DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without Ref,
Spec), CAL
MEAS, DOS
.LP.TRN Transmission of the last measuring
point of the measuring point list in
% MEAS Opt
.LP.UGE Voltage at the generator electrode
for last measuring point of the
measuring point list in V; in case of
measurements with 756, 831: 0 =
not defined, 1 = <14 V, 2 = 14…
28 V, 3 = >28 V KFC, BRC
.LP.VOL Volume for the last measuring point
in the measuring point list in mL DET, MET, SET,
KFT, STAT, DOS
.LPO Current absolute lift position in mm
(entry when ending the command) LIFT
.LST Start time of the loop command
(Date/Time) LOOP, CAL LOOP
.MA.CNT Intensity for maximum measured
value in counts MEAS Opt
.MA.MEA Maximum measured value in the
unit of the measured value DET, MET, SET,
KFT, STAT, MEAS
(without Conc,
Ref, Spec)
.MA.TEM Temperature for the maximum
measured value in °C DET, MET, SET,
KFT, STAT, MEAS
(without Conc,
Ref, Spec)
.MA.TIM Time in s until the maximum meas-
ured value is reached DET, MET, SET,
KFT, STAT, MEAS
(without Conc,
Ref, Spec)
.MA.TRN Transmission for maximum meas-
ured value in % MEAS Opt