Metrohm tiamo 2.2 Manual - Manual (Page 49)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 2 General program functions
tiamo 2.2 ￭￭￭￭￭￭￭￭ 35
Identifica-
tion Description Commands
.DSC Time for processing all start condi-
tions s DET, MET, SET,
KFT, STAT
.DTI Time for drift correction (time from
the start of the titration to the end
of the command) in s SET, KFT, KFC,
BRC
.EGF Last measured gas flow rate (meas-
ured value following processing of
the command) in mL/min MEAS T/FLow
.EME End measured value (measured
value after processing of the com-
mand) in the unit of the measured
value DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without REF,
Spec), CAL
MEAS, STDADD,
DOS
.ENP Electrode zero point for the sensor
used for the command (dimension-
less for pH sensor or in mV for the
ISE sensor) and/or electrode zero
point calculated from the calibra-
tion (for STDADD and CAL LOOP) DET pH, DET U,
MET pH, MET U,
SET pH, SET U,
STAT, MEAS pH,
MEAS U, MEAS
T, MEAS Conc,
STDADD, CAL
LOOP, DOS
.EP{x}.CHA Load for endpoint x (1…9) in mA·s KFC, BRC
.EP{x}.DME Measured value differential for the
endpoint x (1…9) MET
.EP.DVT Drift for the endpoint x (1…9) in
µg/min KFC, BRC
.EP{x}.ERC ERC for the endpoint x (1…9) DET
.EP{x}.MEA Measured value for the endpoint x
(1…9) in the unit of the measured
value DET, MET, SET,
KFT, KFC, BRC
.EP{x}.MEP Quantity of endpoints in the win-
dow x (1…9); 1 = 1 endpoint, 2 =
2 or more endpoints, 3 = EP
corrected with Autodrift, 4 =
EP corrected with manual drift DET, MET, SET,
KFT