Metrohm tiamo 2.2 Manual - Manual (Page 1182)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1168 ￭￭￭￭￭￭￭￭ tiamo 2.2
Note
In order that the event message from the SEND command can be handled
by the RECEIVE command, the RECEIVE command must be running and
at the same time be able to process the message being sent. If, for exam-
ple, a SEND command in track A should start a KFT command in track
B by means of Start titration, then track B must be running and the
conditioning in the KFT command must already be finished (= Cond
ok) at the time that the SEND command is being executed. Otherwise
the command Start titration would be discarded without a message.
Comment
Comment on the event message
Input 250 characters
Default value 'empty'
5.6.9.5 RECEIVE
5.6.9.5.1 RECEIVE - Overview
Dialog window: Method ▶ RECEIVE ▶ Properties... ▶ RECEIVE - 'Command name'
Command for awaiting event messages or status messages produced
by commands.
Appearance
The command has the following appearance:
Parameters
The parameters for the command RECEIVE are configured in the following
dialog window:
￭ RECEIVE - Properties
Command variables
The following command variables are generated in the method run by the
command RECEIVE and can be used in formulas under the designation
'Command name.Variable designation':