Metrohm tiamo 2.2 Manual - Manual (Page 772)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
758 ￭￭￭￭￭￭￭￭ tiamo 2.2
Identification Description
.DRI Current and/or last drift for drift correction in µL/min
.DSC Time for processing all start conditions s
.DTI Time for drift correction (time from the start of the
titration to the end of the command) in s
.EME End measured value (measured value after processing
of the command) in the unit of the measured value
.EP.MEA Measured value for the endpoint in the unit of the
measured value
.EP.MEP Quantity of endpoints 1 = 1 endpoint, 2 = 2 or more
endpoints, 3 = EP corrected with Autodrift, 4 =
EP corrected with manual drift
.EP.TEM Temperature for the endpoint in °C
.EP.TIM Time in s until the endpoint is reached
.EP.VOL Volume for the endpoint in mL
.ETE End temperature (temperature following processing of
the command) in °C
.EVT End volume (total dosed volume at the end of the com-
mand) in mL
.FIN Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command
has never ended
.FP{x}.MEA Measured value for the fixed endpoint × (1…9) in mV
.FP{x}.TEM Temperature for the fixed endpoint × (1…9) in °C
.FP{x}.TIM Time in s until the fixed endpoint × (1…9) is reached
.FP{x}.VOL Volume for the fixed endpoint × (1…9) in mL
.IME Initial measured value (measured value before start
conditions are processed) in the unit of the measured
value
.ITE Initial temperature (temperature before start conditions
are processed) in °C
.LP.CAx Calculated value × (1...3) for the last measuring point
on the measuring point list
.LP.DVT dV/dt for the last measuring point in the measuring
point list