Metrohm tiamo 2.2 Manual - Manual (Page 637)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 ￭￭￭￭￭￭￭￭ 623
Time
Range
0.0 ... 999999.9 s
Volume
Range
0.00000 ... 9999.99 mL
5.6.3.3.5 MET Upol
5.6.3.3.5.1 MET Upol - Overview
Dialog window: Method ▶ MET Upol ▶ Properties... ▶ MET Upol - 'Command name'
Command for Monotonic Equivalence Point Titrations with ampero-
metric measurement (selectable polarization voltage).
Devices
This command can be executed with the following devices.
Titrando: 808, 809, 835, 836, 852, 857, 888, 904, 905, 906, 907
Titrino: 702, 716, 721, 736, 751, 785, 794, 798, 799
Robotic Titrosampler: 855
Appearance
The command has the following appearance:
Parameters
The parameters for the command MET Upol are configured in the following
7 tabs:
￭ General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.
￭ Start conditions
Parameters for the measurement of the initial measured value and for
defining the conditions which have to be met at the start of the titration.
￭ Titration parameters
Parameters for the run of the titration.
￭ Stop conditions
Definitions of conditions which cause the stop of the titration.
￭ Potentiometric evaluation
Parameters for the potentiometric evaluation of titration curves.
￭ Additional evaluations
Definition of additional methods for the evaluation of the titration curves.