Metrohm tiamo 2.2 Manual - Manual (Page 52)

2.4 Formula editor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
38 ￭￭￭￭￭￭￭￭ tiamo 2.2
Identifica-
tion Description Commands
.HP{x}.MEA Measured value for the HNP x (1…
9) in mV (HNP = half neutralization
potential) DET, MET
.HP{x}.TEM Temperature for the HNP x (1…9)
in °C DET, MET
.HP{x}.TIM Time in s until the HNP x (1...9) is
reached DET, MET
.HP{x}.VOL Volume for the HNP x (1…9) in mL DET, MET
.IGF Initial gas flow (measured value at
the time of the start of the com-
mand) in mL/min MEAS T/Flow
.IME Initial measured value (measured
value before start conditions are
processed) in the unit of the meas-
ured value DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without Ref,
Spec), CAL
MEAS, STDADD,
DOS
.ITE Initial temperature (temperature
before start conditions are pro-
cessed) in °C DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without T/Flow,
Ref, Spec), CAL
MEAS, STDADD,
DOS
.LCO Loop counter = current quantity of
completed runs, both of Repeat
loops and of While loops LOOP, CAL LOOP
.LP.CAx Calculated value x (1…3) for the last
measuring point on the measuring
point list DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without Ref,
Spec, Opt), DOS
.LP.CHA Load for the last measuring point of
the measuring point list in mA s KFC, BRC
.LP.CNT Intensity of the last measuring point
on the measuring point list in
counts MEAS Opt