Metrohm tiamo 2.2 Manual - Manual (Page 47)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 2 General program functions
tiamo 2.2 ￭￭￭￭￭￭￭￭ 33
Identifica-
tion Description Commands
.BLV Blank value for the sensor used for
the command (only for ISE sensor)
and/or blank value calculated from
the calibration (for CAL LOOP Conc) DET U, MET U,
SET U, STAT U,
MEAS U, MEAS
Conc, CAL LOOP
Conc, DOS U
.BP{x}.CNT Intensity for the break point x (1…
9) in counts MEAS Opt
.BP{x}.DME Measured value differential for the
break point x (1…9) MET
.BP{x}.ERC ERC or first derivative for the break
point x (1…9) DET
.BP{x}.MEA Measured value for the break point
x (1...9) in the unit of the measured
value DET, MET, MEAS
(without T/Flow,
Ref, Spec)
.BP{x}.TEM Temperature for the break point x
(1…9) in °C DET, MET, MEAS
(without T/Flow,
Ref, Spec)
.BP{x}.TIM Time for the break point x (1…9) in
s DET, MET, MEAS
(without T/Flow,
Ref, Spec)
.BP{x}.TRN Transmission for the break point x
(1...9) in % MEAS Opt
.BP{x}.VOL Volume for the break point x (1…9)
in mL DET, MET
.BSY Command status; 1 = BUSY,
HOLD or ERROR; 0 = READY;
invalid (variable not available) =
Command has never been started All except START
and END
.C0 Coefficient c0 of the calibration
curve CAL Spec
.C1 Coefficient c0 of the calibration
curve CAL Spec
.C2 Coefficient c0 of the calibration
curve CAL Spec
.C3 Coefficient c0 of the calibration
curve CAL Spec