Metrohm tiamo 2.2 Manual - Manual (Page 1179)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 ￭￭￭￭￭￭￭￭ 1165
Command variables
The following command variables are generated in the method run by the
command SEND and can be used in formulas under the designation 'Com-
mand name.Variable designation':
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
not ever been started
.FIN Command status; 1 = Command has been ended at
least once, 0, invalid (variable not available) = Com-
mand has never been ended
5.6.9.4.2 SEND - Properties
Dialog window: Method ▶ SEND ▶ Properties... ▶ SEND - 'Command name'
Command name
Name of the command.
Input 25 characters
All the Event messages listed in the table are sent simultaneously. The table
cannot be edited directly.
Note
A maximum of 10 event messages can be entered.
[New]
Opens the dialog window Send event message for entering a new event
message (see Chapter 5.6.9.4.3, page 1166).
[Properties]
Opens the dialog window Send event message to edit the event message
selected in the table (see Chapter 5.6.9.4.3, page 1166).
[Delete]
Deletes the selected event message.