Metrohm tiamo 2.2 Manual - Manual (Page 55)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 2 General program functions
tiamo 2.2 ￭￭￭￭￭￭￭￭ 41
Identifica-
tion Description Commands
.MA.VOL Volume at maximum measured
value in mL DET, MET, SET,
KFT, STAT
.MI.CNT Intensity for minimum measured
value in counts MEAS Opt
.MI.MEA Minimum measured value in the
unit of the measured value DET, MET, SET,
KFT, STAT, MEAS
(without Conc,
Ref, Spec)
.MI.TEM Temperature with minimum meas-
ured value in °C DET, MET, SET,
KFT, STAT, MEAS
(without Conc,
Ref, Spec)
.MI.TIM Time for the minimum measured
value in s DET, MET, SET,
KFT, STAT, MEAS
(without Conc,
Ref, Spec)
.MI.TRN Transmission for minimum meas-
ured value in % MEAS Opt
.MI.VOL Volume at minimum measured
value in mL DET, MET, SET,
KFT, STAT
.MN.MEA Average of the measured value in
the unit of the measured value MEAS T/Flow
.MR.MRC Correlation coefficient for mean
dosing rate for the whole range STAT, DOS
.MR.MRS Standard deviation for mean dosing
rate for the whole range in
mL/min STAT, DOS
.MR.MRT Mean dosing rate for the whole
range in mL/min. STAT, DOS
.MTE Temperature measurement with
sensor; 1 = on, 0 = off) DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without T/Flow,
Ref, Spec), CAL
MEAS, STDADD,
DOS