Metrohm tiamo 2.2 Manual - Manual (Page 1335)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.2 ￭￭￭￭￭￭￭￭ 1321
6.9 Subwindow Global variables
6.9.1 Configuration - Global variables
Subwindow: Configuration ▶ Global variables
Subwindow Global variables
The subwindow Global variables contains the table with the configured
global variables. It can be shown in the program part Configuration as a
part of the Configuration view or (if not present on the desktop) in a separate
window with View
▶ Quick access. The subwindow can be enlarged and
reduced as required; it can also be maximized.
Using global variables
Global variables are method-embracing variables that are stored overall cli-
ents and can be used in formulas under the designation 'GV.Name'. They
are either entered manually in the configuration or assigned in the method
run by a CALC command.
Note
For global variables which are newly calculated during a determination in
a CALC command and which are saved in the configuration, the current
values are available for additional calculations in the same determinations
from this instant. This is not the case for determinations running at the
same time on other workplaces; here, the values available at the start of
the determination are applied.
6.9.2 Table of global variables
6.9.2.1 Table of global variables
Subwindow: Configuration ▶ Global variables
Contents
The table of global variables shows the following information about the
global variables as standard:
Name
Name of global variable.
Type
Type of global variable (Number, Text or Date/Time).
Value
Value of the global variable.