Metrohm tiamo 2.2 Manual - Manual (Page 115)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 3 Workplace
tiamo 2.2 ￭￭￭￭￭￭￭￭ 101
for the quick selection of methods in the Method field. This button is active
only if more than one method group is present.
Note
If a method is changed and saved in the method editor or during reproc-
essing, then the latest method version will be loaded when a new
determination is started.
Note
The following sample data fields can no longer be edited if they were
defined as Fixed value in the method (see Chapter 5.6.2.2.5, page
427).
Sample position
Position of the sample on the rack. This number is used to move to the
sample position with the command MOVE. For this to be achieved, the
Sample position option must be set under Target for the Move para-
meter.
Range 1 ... 999 (Increment: 1)
Default value 'empty'
ID1…ID16
Sample identifications ID1…ID16. Any text may be entered into this field,
the checking for type and limit values does not take place until the start of
the determination. For sample identifications of the type Date/Time, the
entry must be made in the format YYYY-MM-DD or YYYY-MM-DD
hh:mm:ss. If text templates are defined for the sample identification, then
these can be selected (see Chapter 3.5.1, page 120).
Input 100 characters
Selection Selection of text templates
Sample size
Sample size (initial weight). Only numbers, decimal points, +, –, E and e can
be entered in this field. The checking for limit values does not take place
until the start of determination.