Metrohm tiamo 2.2 Manual - Manual (Page 1362)

7.1 Titrando ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1348 ￭￭￭￭￭￭￭￭ tiamo 2.2
Measuring input 1/2 (iConnect)
ADC type
Shows the type of analog-digital converter.
Serial number
Shows the serial number of the measuring input interface.
Temperature sensor
Selects the type of temperature sensor connected to the measuring input.
With the 856 Conductivity Module displayed only.
Selection
Pt 1000 | NTC
Default value Pt 1000
R (25 °C)
Nominal resistance of connected NTC sensor.
Only visible with temperature sensors of the NTC type.
Range
1000 ... 99999 Ohm
Default value 30000 Ohm
B value
Material constant of the NTC resistance referred to measuring the resistance
at 25 °C and 50 °C.
Only visible for temperature sensors of the NTC type.
Range
1000 ... 9999
Default value 4100
7.1.4 Properties - MSB #
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ MSB #
On the tabs MSB # the properties of the connector and the devices con-
nected to are displayed.
Request for dosing device preparation
Selection when the request for carrying out the command PREP (see Chap-
ter 5.6.6.5.1, page 1108) (prepare) is to be shown for the dosing device
connected to the MSB.