Metrohm tiamo 2.2 Manual - Manual (Page 1147)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 ￭￭￭￭￭￭￭￭ 1133
5.6.7.7.2 RACK - Properties
Dialog window: Method ▶ RACK ▶ Properties... ▶ RACK - 'Command name'
Command name
Name of the command.
Input 25 characters
Device
Device name
Selection of a device from those available in the device table. The only devi-
ces which shall be offered are those with which the command can run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start of
the method.
Device type
Display or selection of the device type. If a device is selected under Device
name, then this Device type field can no longer be edited, and the device
type belonging to the selected device is displayed instead
If the option not defined is selected as Device name, any device types or
device groups which are able to execute the command can be selected,
independently of the devices in the device table.
Selection Device types | 814 USB Sample Processor
Default value 814 USB Sample Processor
Rack test
on | off (Default value: off)
If this option is enabled, the rack attached will be checked to see that it is
the correct one.
Test rack
Selection of the rack name for the rack which must be put on. In this way
you can ensure that the method can only be carried out with this rack. If
another sample rack is detected while executing the command, a message
is displayed and an exit track will be started if there is one defined.
Selection all sample racks listed in the configuration