Metrohm tiamo 2.2 Manual - Manual (Page 1010)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
996 ￭￭￭￭￭￭￭￭ tiamo 2.2
5.6.4.15.2 STDADD man - General/Hardware
Tab: Method ▶ STDADD man ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters
The general parameters for the control device, the sensor and the stirrer are
defined here.
Device
Device name
Selection of a device from those available in the device table. The only devi-
ces which shall be offered are those with which the command can run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start of
the method.
Device type
Display or selection of the device type. If a device is selected under Device
name, then this Device type field can no longer be edited, and the device
type belonging to the selected device is displayed instead
If the option not defined is selected as Device name, any device types or
device groups which are able to execute the command can be selected,
independently of the devices in the device table.
Selection Device types | Titrando
Default value Titrando
Sensor
Measuring input
Selection of the measuring input to which the sensor is connected.
Titrando, 867
Selection
1 | 2
Default value 1
855
Selection
1
Default value 1