Metrohm tiamo 2.2 Manual - Manual (Page 665)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 ￭￭￭￭￭￭￭￭ 651
5.6.3.4.3 SET pH
5.6.3.4.3.1 SET pH - Overview
Dialog window: Method ▶ SET pH ▶ Properties... ▶ SET pH - 'Command name'
Command for Set Endpoint Titrations with potentiometric pH measure-
ment.
Devices
This command can be executed with the following devices:
Titrando: 808, 809, 835, 836, 841, 842, 857, 888, 901, 902, 904, 905,
906, 907
Titrino: 702, 716, 718, 719, 720, 721, 736, 751, 758, 785, 794, 798, 799
Robotic Titrosampler: 855
Appearance
The command has the following appearance:
without conditioning with conditioning
Parameters
The parameters for the command SET pH are configured in the following
8 tabs:
￭ General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.
￭ Start conditions.
Parameters for the measurement of the initial measured value and for
defining the conditions which have to be met at the start of the titration.
￭ Control parameters
Control parameters for endpoint 1 and endpoint 2 (measured values for
the endpoints, titration rate, user defined parameters, stop criterion).
￭ Titration parameters
Parameters for the run of the titration.
￭ Stop conditions
Definitions of conditions which cause the stop of the titration.
￭ Conditioning
Enable/Disable the conditioning. Definition of the start drift, drift correc-
tion and stop conditions.
￭ Additional evaluations
Definition of additional methods for the evaluation of the titration curves.