Metrohm tiamo 2.2 Manual - Manual (Page 564)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
550 ￭￭￭￭￭￭￭￭ tiamo 2.2
Identification Description
.STY Type of stop with which the command was stopped:
1 = normal;0 = manual or after error
.SVA Start volume absolute (volume that was added accord-
ing to the start condition "start volume") in mL
.SVM Start volume measured value (volume which was added
according to the start measured value given in the start
conditions) in mL
.SVS Start volume slope (volume that was added according
to the start condition "start slope") in mL
.SVT Total start volume (volume that was added in depend-
ence on all three start conditions) in mL
.TITER Titer value of the solution used for the command
5.6.3.3.2.2 MET pH - General/Hardware
Tab: Method ▶ MET pH ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters
The general parameters for the control device, the dosing device, the sensor
and the stirrer are defined on this tab.
Device
Device name
Selection of a device from those available in the device table. The only devi-
ces which shall be offered are those with which the command can run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start of
the method.
Device type
Display or selection of the device type. If a device is selected under Device
name, then this Device type field can no longer be edited, and the device
type belonging to the selected device is displayed instead
If the option not defined is selected as Device name, any device types or
device groups which are able to execute the command can be selected,
independently of the devices in the device table.