Metrohm tiamo 2.2 Manual - Manual (Page 1146)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1132 ￭￭￭￭￭￭￭￭ tiamo 2.2
Period of operation
The stirrer can be switched on for a particular period.
Range 0 ... 9999.9
Default value 10.0
Selection s | min
Default value s
5.6.7.7 RACK
5.6.7.7.1 RACK - Overview
Dialog window: Method ▶ RACK ▶ Properties... ▶ RACK - 'Command name'
Command for initialization of the attached sample rack. The rack, lift
and robotic arm (if present) are reset, the rack code is read off and the
corresponding rack data is transferred to the Sample Processor.
Devices
This command can be executed with the following devices:
Sample Processor: 730, 774, 778, 789, 814, 815, 855, 864, 874
Appearance
The command has the following appearance:
Parameters
The parameters for the command RACK are configured in the following
dialog window:
￭ RACK - Properties
Command variables
The following command variables are generated in the method run by the
command RACK and can be used in formulas under the designation 'Com-
mand name.Variable designation':
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
not ever been started
.FIN Command status; 1 = Command has been ended at
least once, 0, invalid (variable not available) = Com-
mand has never been ended