Metrohm tiamo 2.2 Manual - Manual (Page 332)

4.5 Determination overview ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
318 ￭￭￭￭￭￭￭￭ tiamo 2.2
Range 0.01 ... 1000
Default value 0.01
Smoothing factor y-axis
Factor for smoothing on the y axis.
Range 0.01 ... 1000
Default value 0.01
Show with original curve
on | off (Default value: off)
If this check box is activated, then the original curve (solid line, same color)
will be shown in addition to the smoothed curve (dotted line).
4.5.2.6.4.6.4.4 Properties curve evaluation - y2 axis
Tab: Database ▶ Determinations ▶ Reprocess... ▶ Reprocessing ▶ Curve evalua-
tion ▶ [Edit] ▶ Curve evaluation ▶ Properties ▶ y2 axis
On the tab y2 axis the parameters for the graphical display of the curves
on the y2 axis (right y axis) can be set.
Command type
Shows the type of command for which the curve properties can be defined.
The curve properties defined for each command type for the reprocessing
window are saved per client.
Autoscaling
on | off (Default value: on)
If this option is switched on then all axes in the curve window will be scaled
automatically. In this case the fields Start value and End value cannot be
edited.
Size
Selection Command-dependent selection | off
Default value off
Command-dependent selection
Selection of the quantity to be shown on the y2 axis.
Label
Freely definable axis label for the y2 axis.
Selection 50 characters | auto
Default value auto
auto
The designation from the field Size will be used.